User's Manual

Notification CC,V4 (COMMAND_CLASS_NOTIFICATION)
z Trigger Report (movement detected)
1. When the PIR is triggered, it will transmit Notification command to all nodes in Group1 and 3, and Basic set
(0xFF) commands to the nodes in Group 2.
z Restore Report
2. One minute after the trigger, the PIR will transmit Notification restore command to all nodes in Group1 and 3, and
Basic restore (0x00) command to the nodes in Group 2.
z Tamper Report
1. When the Tamper is removed and triggered, it will transmit Notification command (Notification Type:0x06,
Event:0x03) to all nodes in Group 1 and 3.
2. When the Tamper is restored, it will transmit Notification command (Notification Type:0x06, Event 0x00 with one
parameter 0x03) to all nodes in Group 1 and 3.
z Low Battery Report
1. When low battery voltage is detected, the PIR will transmit Battery command to all nodes in Group 1.
2. When PIR on low battery has its battery replaced, it will transmit Battery restore command to all nodes in Group 1
z Factory Reset
1. When the PIR is reset to factory default, it will send Device Reset Locally to all nodes in Group 1.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
. Reorient or relocate the receiving antenna.
. Increase the separation between the equipment and receiver.
. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
. Consult the dealer or an experienced radio/TV technician for help.
FCC Caution : To assure continued compliance, any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment. (Example - use only shielded
interface cables when connecting to computer or peripheral devices).
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.