Operation Manual

ManualsBrandsClimax Technology ManualsElectronicsPanic Button

Panic Button (PB-23)

The Panic Button is used to activate (or deactivate) a panic alarm.

 Parts Identification

1. LED Indicator

The LED indicator will light up briefly when the device is transmitting a signal.

2. Panic Button

1. Press and hold the button for more than 2 seconds to send a

learn code or activate a panic alarm

2. Press and hold the button for 5 seconds to send a Cancel Code to the Control Panel.

(This function is not compatible with every control panel).

3. Battery Compartment

4. 4 x Cover-Fixing Screws

5. Battery Insulator

 Battery

 The Panic Button is powered by one CR123A 3V Lithium battery.

 The Panic Button will transmit any detected low battery status along with any regular status signal

transmission to the Control Panel for display accordingly.

 When changing battery, after removing the old battery, press the button twice to fully discharge

before inserting new battery.

 Supervisory Signal

 The Panic Button will automatically transmit Supervisory Signals every 30 to 50 minutes.

 If the Control Panel has not received the signal from the Panic Button for a preset period of time, the

Control Panel will indicate that the Panic Button is out-of-signal range or is out of order.

 Getting Started

 Pull out the Battery Insulator to power on the Panic Button

 Put Control Panel into learn mode

 Press the button on the Panic Button to transmit a learn code.

 Refer to your Control Panel’s operation manual to complete the learn-in process.

 Walk Test

 Place the Control Panel in the walk test mode, then press the Button once.

 The Panel will display the RSSi (Radio Strength Signal) strength.

Summary of content (4 pages)

PAGE 1
Panic Button (PB-23) The Panic Button is used to activate (or deactivate) a panic alarm.  Parts Identification 1. LED Indicator The LED indicator will light up briefly when the device is transmitting a signal. 2. Panic Button 1. Press and hold the button for more than 2 seconds to send a learn code or activate a panic alarm 2. Press and hold the button for 5 seconds to send a Cancel Code to the Control Panel. (This function is not compatible with every control panel). 3. Battery Compartment 4.
PAGE 2
 Operation    After the Panic Button is learned successfully, press and hold the Button for more than 2 seconds to activate a Panic Alarm. Press and hold the Button for 5 seconds or more will send a Cancel Code to the Control Panel to stop the alarm. (This function is not compatible with all control panels.) Installation A Pad is included into the Panic Button as picture shown below. The padding helps to avoid pressing the button accidently when mounting the Panic Button.
PAGE 3
Surface Placement The Panic Button can be deployed on a flat surface without being installed at a fixed location. 1 Clean the back of the Panic button with degreaser. 2 Remove the protective cover of Anti-Slip pad and apply to the back of Panic Button. (Picture 6) Picture 6 3 Place the Panic Button at desired location.
PAGE 4
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.