User's Manual

z Mounting the Panic Button
The Panic Button can be mounted using two methods: Self-adhesive or Screw mounting.
z Self adhesive mounting
I. Clean the surface with a suitable degreaser.
II. Remove the protective covering from one side of double-sided adhesive pad and firmly apply to back of the
device.
III. Next remove the other covering and firmly place/press the device in the desired location.
<
<
N
N
O
O
T
T
E
E
>
>
)
Do not use the Self-adhesive mounting method on poorly painted and/or rough surfaces.
z Screw Mounting
The Button base has two screw knockouts, where the plastic is thinner for mounting purposes. To mount the Panic
Button:
I. Remove the screw and separate the top cover from the base.
II. Break through the knockouts on the base.
III. Use the holes as a template to drill two holes and insert the wall plugs.
IV. Screw the base into the wall plugs.
V. Secure and screw the top cover back on to its base.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.