Specifications

ManualsBrandsClimax Technology ManualsElectronicsPower Relay Controller

Relay Controller PRL-8-AC(DC)

Introduction

PRL-8 is a Relay Controller that can be connected to wired device and set to either Normal Open (N.O.)

or Normal Close (N.C.) status. After learned into the Control Panel, the Relay Controller can be

controlled via the Panel webpage to remotely open and close the connected device.

Parts Identification

1. Test Button

- Press and hold the button for 3 seconds to send a learn code.

- Press and hold the button while powering on the Relay

Controller, then release the button when the LED lights up to

factory reset.

- Press the button to switch ON/OFF the Relay.

2. LED indicator (Red)

The LED indicator is used to indicate Relay status:

- On: The Relay Controller is turned on.

- Off: The Relay Controller is turned off.

- Flashes twice: When powered on.

- Flashes slowly: Under learning mode.

- Flashes three times: When learning is successful.

- Flashes briefly: RF signal transmitting

Connection Terminals

Connect the wire into the terminal, tighten the screw to close the

clipper and hold wire in place. Unscrew to open the clipper to

remove the wire connected to the terminal.

3. Line (AC input) or 12V/24V DC Input (+)

4. Neutral or Ground (-)

5. NO

For Normal Open connection with the device.

6. Common

7. NC

For Normal Close connection with the device.

8. Strain Relief Clamp

The clamp is used for securing the wires, and providing strain relief to protect the

wires from the metal cutout.

9. Wiring Buckle

The Wiring Buckle is used for managing wires.

Specification

 Power Source (External Power): 100-240VAC or 12/24VDC

 Relay Output: Potential-free SPDT relay, Maximum Operation Load: 10A (Resistive) at

24VDC or 240VAC

 Stranded Wire: 14 ~ 22 AWG

 Operating Temperature: -10°C to 45°C (14°F to 113°F)

 Humidity: Up to 85% non-condensing

 Dimension: 86mm x 72mm x 29mm

Installation Environment

 The Relay Controller should be installed indoors in a dry location.

Summary of content (4 pages)

PAGE 1
Relay Controller PRL-8-AC(DC) Introduction PRL-8 is a Relay Controller that can be connected to wired device and set to either Normal Open (N.O.) or Normal Close (N.C.) status. After learned into the Control Panel, the Relay Controller can be controlled via the Panel webpage to remotely open and close the connected device. Parts Identification 1. Test Button - Press and hold the button for 3 seconds to send a learn code.
PAGE 2
 It is recommended to install the device in a fire resistant plastic gangbox.  Do not install the device in a metal gangbox for optimization of RF range. Caution  All works on the device, including installation and maintenance, must be performed by a qualified and licensed electrician.  To prevent electrical shock and/or equipment damage, disconnect electrical power at the main fuse or circuit breaker before installation and maintenance.
PAGE 3
Walk Test To test whether the Relay Controller is able to communicate with the Control Panel:  Put the Control Panel into Walk Test mode.  Press the Test Button on the Relay Controller.  The Control Panel should display if the Relay Controller is within the operation range (please refer to the operation manual of the Control Panel).
PAGE 4
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.