Parts List
4
One-way/Two-way setting
The Repeater can operate as either a one-way device or two-way device. When
programmed as a two-way device, the Repeater can receive acknowledgement from the
Control Panel to ensure successful transmission.
The repeater will work as a two-way device when DIP Switch 6 is slid to the ON position. It
will work as a one-way device when DIP Switch 6 is slid to the OFF position.
Please set the DIP Switch 6 position for One-way/Two-way device when the Repeater is
off. After setting is complete, please power on the repeater and learn/re-learn it into the
Panel for the setting to take effect.
Learn into Control Panel
Step 1 To learn the Repeater into the Control Panel, slide DIP Switch 4 to the On position under
Normal Mode. The Repeater will emit 1 long beep and the Yellow LED will turn on.
Step 2 Put the Control Panel into Learning Mode (please refer to the Control Panel manual).
Step 3 Press the Test button. The Repeater will transmit a Test Code to the Control Panel as the
Red LED lights up and the Repeater emits 1 beep.
Step 4 If the Repeater receives an acknowledge signal from the Control Panel within 60 seconds,
Learning is successful. The Blue LED will light up for 1 second as the Repeater emits 1 long
beep.
If the Repeater fails to receive an acknowledge signal from the Control Panel within 60
seconds, learning has failed and is indicated by the Yellow LED flashing 3 times. Please
repeat step 3-4 again.
Step 5 Slide DIP Switch 4 to the Off position. The Repeater will emit 1 long beep and the Yellow
LED will turn off as the Repeater returns to Normal Mode.
Learning Repeater into Repeater
If Repeater A is learning into Repeater B:
Step 1 Putting Repeater B into learning mode: Under Normal Mode, slide DIP Switch 1 of Repeater
B to the On position. Repeater B will emit 1 long beep and the Yellow LED will flash slowly
(1 flash every 2 seconds).
Step 2 Press the Test Button on Repeater A to send a learn code. Repeater A will emit 1 beep and
the Red LED will turn on.