Wrist Transmitter eo Features ® Tamper Proof -Any attempt to tamper with the Wrist Transmitter after installation will stop the operation of the Transmitter and will be detected by the Base Unit immediately. ® Water proof . Lightweight (0.90Z only) ® Code Hopping encryption avoids any possibility of code duplication. ® Easy range check.
2] Test Button ® During Learning, press the Test Button, the Wrist Transmitter will send the "Learning code” for the Base Unit to learn the iD code of the Wrist Transmitter. ® After installation, press Test Button, a test signal will be send. If the Base Unit receives the test signal, it will sound beeps. 3] Fastening Pin ® The two pins is used to fasten the belt in its position.
e Installing the Wrist Transmitter After the ID Case of a Wrist Transmitter is learned by the Base Unit, the Wrist Transmitter is paired with the Base Unit and is ready for installation, Step 1. Step 2. Step 3. Step 4. Step 5. Find a suitable length for the subject and locate the v-cut line near-by on the belt. Trim the belt along the v-cut line.
© Battery Life & Low Battery Detection © The Wrist Transmitter uses one 3V 500mAh lithium battery and will fast for at least 12 months. @ If the battery voltage is less than 2.7V, the Wrist Transmitter will send “Low Battery” signal to the Base Unit. The Base Unit will then notify the Monitoring Station the Transmitters battery is low and needs replacement. e FCC Notice Model:WT-2 FCC ID:GXOWT THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.