User's Manual

9

Commands (20-24) are used to program
the Alarm reporting method for each Tel.
Number.
 Command (20): Program the same Alarm
Reporting Method for all 4 Tel. Numbers.
 Command (21-24): Program the alarm
reporting method for the 1
st
-4
th
Tel.
Numbers respectively.
 Available Options:
<NOTE>
 The latest Command (20-24) setting(s)
will overwrite any previously entered
setting(s).
 If Speech Method is selected:
After the dialing for alarm/emergency
trigger is successful, CTC-1052-QT-
DT35A opens a two-way voice
communication between the Call
Recipient and CTC-1052-QT-DT35A for
1-10 minutes (set by Command #46).
If the Call Recipient needs more talk
time, they can press any keys except 9
or 0 on their phone set to reset to the
original communication duration (set by
Command #46).
To terminate the call, press (9) or
RESET BUTTON on CTC-1052-QT-
DT35A.
During the Speech period, CTC-1052-
QT-DT35A will emit two beeps via the
telephone handset to alert the call
recipient the remaining time of 20 & 10
secs.
 Speech Reporting made under Silent
Mode (set by Command #35) will
automatically be switched to Listen-in,
but call recipient can press DTMF keys
to open two-way communication or
change modes.
 If any of SMS Reporting Methods is
selected:
Once alarm or emergency data is
successfully transmitted, the CTC-
1052-QT-DT35A will automatically send
out a SMS (CID) Message.
Command 31
Ringer Enable for Incoming Calls
 CTC-1052-QT-DT35A can be programmed
to emit a ring tone as an audio alert, or
silent for incoming calls.
Function Selection Result
(0)
OFF
(Ring Tone Disable)
(1)
ON
(Ring Tone Enable)
 Factory Default is set as (0), OFF.
 If the function is set to ON, you can answer
the incoming call by pressing the Active
button of WTR, PB, or Fall Sensor, or the
Help Button on CTC-1052-QT-DT35A.
 The time-out period for the incoming call is
30 minutes.
 To terminate the incoming call, either press
the Active button of WTR, PB, or Fall
Sensor, or press the Reset Button on
CTC-1052-QT-DT35A.
 During the AC Power failure period, Ring
Tone is automatically disabled.
Command 32
Audible Fault Alert
 CTC-1052-QT-DT35A can be programmed
to emit Fault Alert Beeps every 30
seconds from AC Failure.
Function Selection Result
(0)
OFF
(No Warning Beep)
(1)
ON
(With Warning Beep)
 Factory Default is set as (0), OFF.
Command 34
Method
Function
Selection
Speech
Method
(3)
Open Two-way
communication
SMS
Reporting
Method
(4) SMS (CID)