User's Manual

16
Function Selection Result
(0) Any DTMF
(1) OFF-HOOK
Command 80-82
Remove Devices
 CTC-1052-QT-DT35A can be programmed
to remove ALL previously learnt devices by
entering (80) followed by (＃).
After entering command (80) (＃), the
system will immediately emit an
acknowledging beep over the phone.
Continue to hold the phone set until you
hear the second acknowledging beep after
12 seconds.
 Command 81 is used to remove Zone 1
device.
 Command 82 is used to remove Zone 2
device.
Command 93
Learn-In Silent Pendant
<NOTE>
 This command is not available in
Remote Programming Mode. It is only
available in PC programming mode.
 For learning Silent Pendant:
Step 1: Click the Start button besides 93#
(Learn-in Silent Device) to enter
learning mode, a “Panel in learning
mode. Please press Device Button!”
message will pop up.
Step 2: Press the Pendant Button within 20
seconds.
 Learning can only be completed
within the signal reception range of
CTC-1052-QT-DT35A.
 If no signal is received within 20
secs, CTC-1052-QT-DT35A will
emit a long beep and automatically
returns to Programming mode.
Step 3: CTC-1052-QT-DT35A will emit 2
beeps to indicate that Silent Pendant
is learnt-in successfully.
 Adding a device for a second time is
prohibited unless it is removed from
the system first.
 If one long beep is emitted instead
of 2 beeps, it indicates:
 The device has already been
learnt-in.
 When the 21
st
device is attempted
to learn-in.
<NOTE>
 When CTC-1052-QT-DT35A received
the alarm signal from the Silent
Pendant, it will not emit any warning
beeps during Reporting and Guard time
period.
Command 94
Learn-In Device
<NOTE>
 This command is not available in
Remote Programming Mode. It is only
available in PC programming mode.
 Up to 20 devices can be learnt into CTC-
1052-QT-DT35A by using Command #93 or
#94.
 The available devices that can be learnt-in
Command #93 or 94 are:
 PIR Sensor ----- PIR
 Smoke Detector ---- SD
 Carbon Monoxide ---- CO
 Fixed Panic Button ---- PB
 Wrist Transmitter ---- WTR
 Pendant Transmitter ---- WTR
 Water Sensor ---- WS
 Fall Sensor
 Carbon Dioxide Detector ---- CO2
 Temperature Sensor ---- TS
Step 1:
Click the Start button besides 94#
(Device) to enter learning mode, a
“Panel in learning mode. Please
press Device Button!” message will
pop up.
Step 2: Press the learn button on the device
within 20 seconds.