User's Manual

41
 The Guard Time Delay triggered from a
fall detection (of a Fall Sensor) has its
own timer (programmed using
Command 66). The CTC-1052-QT-
DT35A will play voice prompt “A fall has
been detected,” to notify the user; and
“Fall detection has restored, cancelling
help call” voice prompt, when fall
detection has been cancelled.
Confirmation Voice Prompt
 After Guard Time expires, CTC-1052-
QT-DT35A will summon help based on
the programmed reporting method. The
Control Panel will play a voice prompt
“Emergency call in progress” to
indicate that the call is in progress.
 The Control Panel will play voice prompt
during the following situations:
 After the Control Panel dials out to
summon help and until handshake (for
Digital Reporting Method).
 After the Control Panel dials out to
summon help and until the call is
answered (for Speech Reporting
Method).
 When the first reporting failed, and the
Control Panel retries.
 The Control Panel stops playing
confirmation voice prompts once the first
reporting succeeded and Control Panel is in
the process of back-up reporting.
5.2.1. GPRS Reporting Method
 Please program GPRS Report settings via
SMS Remote Programming Commands for
GPRS Reporting Methods. Below are the
settings required for GPRS reporting:
 Access Point Name (APN): the name of
an access point for GPRS. Please inquire
your SIM card service provider for your
APN.
 User Name: offered by your SIM card
service provider. Please inquire your
service provider for your GPRS username.
If no username is required, you may skip
this step.
 Password: offered by your SIM card
service provider. Please inquire your
service provider for your GPRS password.
If no Password is required, you may skip
this step.
 IP Address: Central Monitoring Station
server IP. Please refer to 4.3.1 1052-QT-
DT35A SMS Remote Programming Table
on how to set CMS IP Address(es) (SMS
Commands: TCIP1 and TCIP2).
 Port Number: Central Monitoring Station
server port number. Please refer to 4.3.1
1052-QT-DT35A SMS Remote
Programming Table on how to set Port
Number(s) (SMS Commands: PORT1 and
PORT2).
 GPRS/IP Account Number: There are 2
account numbers available for GPRS/IP
reporting. Please refer to 4.3.1 1052-QT-
DT35A SMS Remote Programming Table
on how to set GPRS/IP Account Number(s)
(SMS Commands: IPAC1 and IPAC2).
 To disable GPRS Reporting Method: by
removing the IP address, GPRS reporting
becomes ineffective. Proceed to SMS
Remote Programming and send in this
format:
“PROG 8744 TCIP1:”
Where:
PROG = SMS Keyword
1111 = Access Code
TCIP1 = SMS command for IP Address (no
input value means deletion of characters)
5.2.2. SMS CID Reporting Method
 If SMS CID reporting is selected, the event
codes will be sent in the form of a SMS
message to the reporting destination.
Post-Digital-Alarm Operation
 After a successful report, CTC-1052-QT-
DT35A will then follow the choice of
Command #38, to enter Call-Back or
Follow-On & Call-Back mode.

Call-Back Operation
 If Command #38 is set as Call-Back (1) or
Follow-On & Call-Back (2) after alarm
reporting, it will then wait 5 minutes for
Monitoring Center Personnel to call-back
after reporting.