Installation Instructions
Table Of Contents
- 1. Introduction
- 2. System Overview
- 3. Getting Started – Setting up Mobile Lite
- 4. Programming Mobile Lite
- 5. Local RF Device Management
- 6. Operation
- 7. Appendix
- I. Federal Communication Commission Interference Statement
4. Programming Mobile Lite
Mobile Lite can be programmed by using a PC Programming Tool.
4.1. PC Programming Tool (Installers Only)
For system setting programming with PC Programming Tool software via USB
port, follow instruction below.
Step 1. Execute the programming tool:
The following configuration screen will be opened.
Step 2. Select the following settings in the top section of the configuration
screen and click “Open.”
Port: Select the COM port generated for Mobile Lite after
installing the USB Driver (the USB port connected to Mobile
10