Installation Instructions

(9) to reset the communication time to its preset duration.
 If no DTMF command is pressed during the speech period, the call will
automatically hang up and be recorded as an unsuccessful report. Each
phone number will be retried up to a maximum of 2 times accordingly.
 During two-way communication, Mobile Lite location info will be updated
every minute, if there was a successful IP report before the current
two-way communication, the location updates will be reported in event via
the previously successful IP channel.
6.4.4. Report Sequence
The Reporting Group determines the sequence of reporting.
One Report Index can only be assigned to one Group.
Reporting within a Group:
If there are multiple Report Indexes programmed within a Group:
 Mobile Lite will report according to the numeric order (e.g. 1 > 2 > 3, etc.)
of the Report Index in a Group. Report will stop when one report is
successful and Mobile Lite will regard reporting to this Group successful.
For example, if Report Index 1 and 4 are assigned to Group 1, Mobile Lite
will stop reporting if reporting to Index 1 is successful. If reporting to Index
1 failed, Mobile Lite will carry on reporting to Index 4.
 If all reporting in a group failed, Mobile Lite will retry reporting.
Mobile Lite will try reporting within the same group for up to three times,
(or until one of the reports is successful). If three times of trying within the
same group failed, Mobile Lite will regard reporting to this Group
unsuccessful.
From the example above, suppose all report failed, the report sequence
would be:
1 > 4 > 1 > 4 > 1 > 4
Reporting Cycle
 If multiple groups are assigned to the same event type (emergency or
status), Mobile Lite will report according the group numeric order from the
first programmed Group to the last programmed group. This report
sequence is one reporting cycle.
 Reporting cycle is regarded as successful if any Group is successful, but
Mobile Lite will terminate reporting only after completing the reporting
cycle (going from the first programmed group to the last programmed
group).
 Reporting behavior depends on the event type:
33