Installation Instructions

For example, if Groups 1 and 3 are programmed for “Status”
reports:
Group 1 > Group 3 > Stops reporting
6.5. Sleep Mode
Mobile Lite R32 can be put to Sleep Mode to conserve battery power.
During Sleep Mode, Mobile Lite R32’s cellular module is powered off when idle.
Mobile Lite R32 will power on its cellular module in the following situations.
1) Alarm is activated
When an alarm is activated by pressing the Active Button of Mobile Lite or
the learnt-in RF device (WTR, Fall Sensor or PB), or pulling the cord of
PCU, or when a fall is detected, Mobile Lite will wake up to transmit alarm
report to CMS. Other status signals in queue buffer will be sent as well.
2) Auto Check-In Report
Users can program the length of the interval between auto check-in
reports in sleep mode.
When the Mobile Lite makes the auto check-in report to CMS, status
signals in queue buffer will be sent as well.
3) Low battery Detection
When Mobile Lite is low on battery, Mobile Lite will wake up to make Low
Battery report.
If battery is not charged after making Low Battery report, Mobile Lite will
wake up to make the second Low Battery report when battery voltage
drops too low.
Other status signals in queue buffer will also be sent along with low
battery report.
6.6. Check Device Information
To check Mobile Lite R32’s information, press the Info button once in normal
mode. The device will beep once and play voice prompt, annoucing the device
state including connectivity status and battery level.
35