Installation Instructions
Table Of Contents
- 1. Introduction
- 2. System Overview
- 3. Getting Started – Setting up Mobile Lite
- 4. Programming Mobile Lite
- 5. Local RF Device Management
- 6. Operation
- 7. Appendix
- I. Federal Communication Commission Interference Statement
2. System Overview
2.1. Identifying the Parts
Button/LED/Component
Behavior
Function/Indication
1. Microphone
2. Green LED
On
Full Charged
1 flash every 2 minutes
Charging or in use (battery
percentage > 20%)
Normal Cellular Network
connection
Red LED
1 flash every 30 seconds
Low battery (battery percentage is
10% - 20%)
On
Low battery (battery percentage <
10%)
Charging (battery percentage <
20%)
Amber LED
1 Flash every 1 minute
Cellular Network fault
All LEDs ON
During Firmware Update
3. Active Button (Help
Button)
Press for 2 seconds
Trigger emergency alarm
Press and hold for 5 seconds
during a Guard Time
Cancel alarm
Press and hold for 5 seconds
during a call
Terminate the call
4. Speaker
5. Info Button
Press once
Check cellular signal strength and
battery level
Press twice quickly
Enter the Test Mode
Press 3 times quickly
Enter the Pairing Mode
Press 4 times quickly
Power off the device
2