Specifications

>MOTION AREA SETUP<

FACTORY DEFAULT is all sections set to ON (GREEN)

**If application requires all sections set to ON, there are no changes to this menu

required.

If changes are required then press ENTER to turn MASK ON.

WALK ON MODE: Select single sections by moving pink cursor.

WALK OFF MODE: Clear single sections by moving blue cursor.

BLOCK ON MODE: Select blocks by moving cursor horizontally than vertically.

BLOCK OFF MODE: Clear blocks by moving cursor horizontally than vertically.

ALL ON MODE: Select all area mode ON. (SELECT)

NOTE: FACTORY DEFAULT

ALL OFF MODE: Select all area mode. OFF (CLEAR)

1 Section 1 Block

Adjacent Sections=1 Block