Instruction Manual

ManualsBrandsClinton Electronics ManualsCamcordersCE-T909

Included Items:

• Camera x 1

• Allen Wrench x 2

• Instructions x 1

• Phillips Head Screws x 3

Required Items:

• Phillips Head Screwdriver

Optional Items:

• CE-REMOTE

• Drill w/ Phillips Head Bit

To ensure quality operation, verify proper BNC and power termination; along with proper

voltage at camera.

TO DVR/MONITORTO CAMERA

BNC CONNECTION

POWER CONNECTION

T909

1. DISASSEMBLE

2. CAMERA MOUNTING

4. REASSEMBLE

INSTALLATION GUIDEINSTALLATION GUIDE

3. ATTACH CABLES

Place the camera body into the socket of the mounting plate. Then place the outer

plate over the camera body and mounting plate. Loosely tighten the set screws to hold

the camera together.

SET SCREW

MOUNTING PLATE CAMERA BODY OUTER PLATE

Ax the mounting bracket to the surface with the 3 supplied Phillips head screws. Feed the cable from the camera through the center of the mounting plate. Make connec-

tions to the BNC cable and the power connection. Feed any cable slack into the

mounting surface.

With the supplied Allen wrench, loosen the 2 set screws located on the outer plate.

Carefully seperate the mounting plate from the outer plate and camera body.

Remove the protective ﬁlm over the lens.

v.05.29.13

The set screws will be tightened after camera adjustments are made.

*Information in this document is subject to change

Clinton Electronics

Summary of content (2 pages)

PAGE 1
T909 Included Items: • Camera x 1 • Allen Wrench x 2 • Instructions x 1 • Phillips Head Screws x 3 Required Items: • Phillips Head Screwdriver Optional Items: • CE-REMOTE • Drill w/ Phillips Head Bit INSTALLATION GUIDE 1. DISASSEMBLE a. With the supplied Allen wrench, loosen the 2 set screws located on the outer plate. b. Carefully seperate the mounting plate from the outer plate and camera body. SET SCREW MOUNTING PLATE CAMERA BODY OUTER PLATE 2. CAMERA MOUNTING 3.
PAGE 2
5. CAMERA ADJUSTMENT a. Camera plate rotation can be adjusted by turning the camera to the desired location. b. Lens angle can be adjusted by tilting to the desired location. 180° 360° Take notice of location of cable exiting the back of the camera body. Depending on angle of lens there is potential for stretching or pinching of cable. Rotate camera body or outer plate as necessary. c. Barrel rotation can be adjusted by rotating the camera body to the desired location. d.