User's Manual

10 11
PREPARE STREAMER
The very fi rst time your Streamer is used with the TeleAdpater, the two devices must be
paired together.
PAIRING:
1. In order to prepare the Phone adapter and Streamer as a pair, both devices are placed
close to each other and pairing mode is activated.
2. Press Streamer Connect button for  seconds until the blue light
starts fl ashing rapidly.
3. Press the red Phone button on the Phone adapter for  seconds until
the red status indicator blinks.
4. Within a minute the Phone adapter connects to the Streamer and pairing is complete.
- the red status indicator of the Phone adapter gives constant red light.
- the blue light in Streamer Connect button gives constant light for 5 seconds and then
shows slow fading light.
Pairing is done only once and will normally not have to be repeated.
STATUS
AT
T
U
TIPS AND SUPPORT
Place the Phone adapter unit in a suitable spot near your land line phone or base station.
For using the land line phone through the Phone adapter and Streamer, refer to the user
guide.
Turn o the Phone adapter
If you don’t want to receive phone calls to your Streamer, turn o the Phone adapter by
disconnecting power.
For normal use, the Phone adapter uses very little power so it is not necessary to turn it o .
Phone adapter range
The Phone adapter has a range of about  meters depending on furnitures and placement.
Within this range you can make hands free phone conversations with Streamer.
For further support or tips you can check the ConnectLine information on
www.oticon.com/connectline