User manual

10
[Important Check Points before Phonizer-CFA evaluation]
The following items must be checked before starting Phonizer-CFA evaluation.
① Remove the power cable from your PDA and make it sure that the PDA is off the
cradle before the calling test.
② When the power is being fed to the PDA, the voice quality may be degraded due to
60Hz humming noise.
③ Ensure that the remained battery power level is over 80% during the call test.
④ Battery power level of 50% or below may cause the power failure of the Bluetooth
module.
⑤ When the remained battery power level is 50~80%, some noise may occur during the
call.
⑥ When you are using the PDAs, such as iPAQ3870, iPAQ3970, and iPAQ5450, with
built-in Bluetooth or wireless LAN modules, make it sure to disable the built-in
Bluetooth or wireless LAN module on the PDA. Otherwise the Phonizer-CFA software
will try to communicate with the built-in Bluetooth or wireless LAN module instead of
Clipcomm's Bluetooth CF card (CBT-CFA).
⑦ Insert CBT-CFA properly into the slot of expansion pack.
⑧ Please use only the earset provided by Clipcomm.
⑨ Insert the earset completely into the side hole of CBT-CFA card.