Specifications
Table Of Contents
- Contents
- 1.0 Product Range
- 2.0 Important Notes
- 3.0 Description
- 4.0 Definitions
- 5.0 Installation Procedure
- 6.0 Mounting Instructions
- 7.0 Wiring Details
- 8.0 C-Bus System Clock
- 9.0 C-Bus Power Requirements
- 10.0 Power Surges and Short Circuit Conditions
- 11.0 Megger Testing
- 12.0 Programming Requirements
- 13.0 Using the C-Touch Colour Transfer Utility
- 14.0 Electrical Specifications
- 15.0 Mechanical Specifications
- 16.0 Standards Complied
- 17.0 Warranty
C-Touch Colour Touch Screen
12
To mount the C-Touch Colour using the nail bracket:
1) Place the bracket against a beam of the wall frame.
2) Nail the bracket into the frame. Alternatively mark and drill the
holes, then screw the bracket into the frame.
3) Feed the cables through to the nail bracket. The use of conduit is
recommended. Refer to
Figure 6. The number and positioning of
cables will vary depending on the particular installation. Possible
cables are listed in
Table 1.
4) Hold the C-Touch Colour unit up to the nail bracket and plug the
cables into the connectors.
5) Insert the unit into the nail bracket, lining the mounting holes up
with those in the bracket. Fix the C-Touch Colour to the nail
bracket using the four screws provided. Do not over tighten.
Cable Connection Quantity Connector Location
C-Bus RJ45 2
Serial RS-232 DB9 1
Infrared
(input)
3.5 mm
mono socket
1
Audio line in 3.5 mm
stereo socket
1
Audio line
out
3.5 mm
stereo socket
1
Serial USB USB Type A 2
Cat-5
network
RJ45 2
(1 front,
1 back)
DC power 4 pin DIN 1
PS/2 mouse
or keyboard
6 pin mini
DIN
1
Video out RCA 1
Table 1 – C-Touch Colour cable connections and location