Specifications
Table Of Contents
- Contents
- 1.0 Product Range
- 2.0 Important Notes
- 3.0 Description
- 4.0 Definitions
- 5.0 Installation Procedure
- 6.0 Mounting Instructions
- 7.0 Wiring Details
- 8.0 C-Bus System Clock
- 9.0 C-Bus Power Requirements
- 10.0 Power Surges and Short Circuit Conditions
- 11.0 Megger Testing
- 12.0 Programming Requirements
- 13.0 Using the C-Touch Colour Transfer Utility
- 14.0 Electrical Specifications
- 15.0 Mechanical Specifications
- 16.0 Standards Complied
- 17.0 Warranty
Installation Instructions
17
To remove the facia:
1) Grasp the right side of the facia with your left hand.
2) Push the release lock in with your right thumb. At the same time
lift the right side of the facia plate off and to the right with your
left hand (to disengage the clip.
3) Swing the facia off towards the left. Refer to
Figure 10.
Lift off and to the right to disengage
the clip, then swing to the left
Push the
release lock
Figure 10 – Removing the facia
7.0 Wiring Details
7.1 C-Bus Network Connection
Connection to the C-Bus network is made via one of the RJ45 sockets. Use
Cat-5 Unshielded Twisted Pair (UTP) C-Bus cable, and an appropriately
wired RJ45 plug. Pinouts and cable conductor assignments are provided in
Figure 11 and Table 2. The C-Bus RJ45 sockets are internally connected
together. The Clipsal catalogue number for the C-Bus Cat-5 UTP cable is
5005C305B.