Specifications

C-Touch Colour Touch Screen
24
1) Once the C-Touch Colour has been installed and switched on, you
should see the default screen in
Figure 14. You must configure the
unit with an IP address and customised project file, before it is ready
for use.
Figure 14 – The initial screen of an unconfigured C-Touch Colour Touch Screen
2) Remove the facia if it has been fitted to the unit (refer to page
17).
3) Plug the supplied programming lead (red crossover cable) into the
RJ45 Ethernet socket on the front right side of the unit.
4) Plug the other end of the patch cable into the Ethernet socket on
your PC.
5) Start the C-Touch Colour Transfer Utility software. (This can be started
by clicking on the Transfer icon of the PICED software).
6) You will be presented with a list of network cards present in your PC
(
Figure 15). Select the network card to which you have connected the
patch cable and click Next (most PCs only have one network card).