Specifications

15 of 36

50x0CTC3 Series C-Touch Colour Touch Screen Installation Instructions

4.0 Wiring Details

All of the wired cable connections to the touch screen use quick disconnecting type

plugs. Be sure to connect the cables to the correct locations before installing the

touch screen in its mounting bracket with the four mounting screws.

4.1 C-Bus Network Connection

Caution

The C-Bus network must not be connected to any other type of network.

Make certain that only the C-Bus network cable is inserted in the

C-Bus RJ45 connectors. Improper connection will cause damage to the

equipment.

Two RJ45 connectors are located on the back panel for C-Bus network connection.

This allows the touch screen to be placed anywhere on the network. Use Cat.5e

Unshielded Twisted Pair (UTP) cable. Catalogue numbers are 5005C305B (solid)

and 5005C305BST(stranded). The pin assignments for the cable conductors are

shown in Table 2

87654321 87654321

Pin C-Bus Connection Colour

1 Remote ON green & white

2 Remote ON green

3 C-Bus Negative (-) orange &white

4 C-Bus Positive (+) blue

5 C-Bus Negative (-) blue & white

6 C-Bus Positive (+) orange

7 Remote OFF brown & white

8 Remote OFF brown

Table 2. RJ45 cable conductors for C-Bus.

C-Bus network cables must be kept separate from mains cabling. To avoid problems

caused by induced electromagnetic noise, never run the network cable parallel to

mains wiring or place the cable inside a conduit that contains mains conductors.