Specifications

18 of 36

50x0CTC3 Series C-Touch Colour Touch Screen Installation Instructions

4.6 Wired LAN Connection

Caution

The Ethernet LAN network cable must not be connected to the C-Bus

cable connector on the back panel. The two networks are not electrically

compatible and improper connection will cause damage to the equipment.

The 5000CTC3 touch screen supports a wired Ethernet LAN connection at the rear

panel. The connection method used is a matter of choice. A wired LAN connection

requires a switch/hub or router, not supplied by Clipsal. Be sure to use high quality

Cat.5e cable for the LAN connection. Conduit is recommended. Do not run network

cables near mains power cables or near sources of interference such as light

ﬁxtures or transformers.

4.7 Keyboard Connection

You can connect a keyboard to the touchscreen for conguration and support

purposes. The connection is not intended to be permanent. You can use either of

thefollowing methods to connect a keyboard:

PS/2 Port

The keyboard may be connected directly to the PS/2 port.

USB Ports

You can connect a USB keyboard to either of the USB ports on the back panel.

Use care when the touch screen is not ﬁrmly attached to the mounting box or

bracket. After completing the programming tasks, be sure to securely attach the

touchscreen and install the front fascia.

4.8 Programming Lead

A programming lead is provided with the touch screen. It consists of a Cat.5e

crossover Ethernet patch cable. Use the crossover programming lead when

connecting directly from a PC to the touch screen. If connecting through a network

hub or switch, you will need to use a standard Ethernet cable. Cable conductor

assignments for a crossover Ethernet cable are shown in Table 4.

Connection A Connection B Colour

1 3 Green/White

2 6 Green

3 1 Orange/White

4 4 Blue

5 5 Blue/White

6 2 Orange

7 7 Brown/White

1 234567 8

8 8 Brown

Table 4. Wiring assignments for a crossover Ethernet patch cable.