Specifications

7 of 36

50x0CTC3 Series C-Touch Colour Touch Screen Installation Instructions

2.0 Safety and Product Handling

Be aware of the following information during installation:

• The touch screen and its power supply are for indoor use only.

• Use only the approved power supply with the touch screen (see Table 1).

• Do not connect the C-Bus cables to any other network. Damage to the

equipment will occur.

• Allow adequate ventilation. Do not block the air vents at the top of the unit.

• Using any non-C-Bus software on the touch screen without the written consent

of Clipsal or Schneider Electric may void the unit’s warranty.

• Do not overtighten the mounting screws. The case might distort and cause

problems installing the front fascia.

• Do not megger test the touch screen or the C-Bus network cables.

• Use only the cleaning cloth provided to clean the screen.

3.0 Installation

When installing the touch screen, be careful not to scratch or otherwise damage the

plastic parts. Do not wipe the screen with anything other than the a clean soft cloth.

Refer to the User’s Guide for care instructions.

3.1 Location

It is important to select the right location for the touch screen. Follow these

guidelines when choosing a location for the unit:

• Choose a location away from direct sunlight or bright lights that will cause

unwanted reﬂections.

• Avoid damp or humid locations or places where water might drip on the

touch screen.

• Provide a clear area in front of the touch screen for reception of signals from the

infrared remote control.

• The touch screen viewing angle is shown in Figure 4.

• Do not install the touch screen near sources of heat, such as hot air vents

or heaters.