Specifications

Multi Room Audio Matrix Switcher and System Installation Instructions
10
• Avoid laying Digital Audio cables along side mains cabling, as electromagnetic
interference (EMI) can disrupt the audio signal.
• You can terminate the Digital Audio cable at a wall plate and run the cables
inside the wall to the amplifier, or a wall plate near the amplifier. Then you can
use patch leads from the matrix switcher to the wall plate.
Note: The MRA amplifiers can be configured using a loop in-loop out connection for
digital audio and IR, but not for power. Additional amplifiers will require a
separate power supply. Refer to the
C-Bus Multi Room Audio Amplifier
Installation Instructions
.
If loop-in, loop-out is required with the Low Power Remote amplifier, a
5600TEE will be needed.
Figure 6 shows the connections from the matrix switcher to the MRA amplifiers. In
the illustration, an optional MRA distribution unit provides an additional audio input
source.
Figure 6. Digital Audio cable connections