Technical data

Care and Cleaning
S3000 products are designed for durability and resistance to marking.
Over time, however, normal usage can result in the build-up of dust
and grime from nger marks etc.
Like most wall plate ranges in South Africa, the polycarbonate
material that provides with their strength and toughness can be
susceptible to physical degradation over time if subjected to certain
chemical compounds, including those that may be found in some
common household cleaners.
S3000 products should only be cleaned with a water dampened cloth
in order to maintain their optimum appearance and longevity.
Assembly and Wiring
GENERAL INSTRUCTIONS
- It is illegal for persons other than those authorised by legislation to work on the xed wiring of any electrical installation.
- All installations must be in accordance with local Electrical Wiring Regulations and Building Codes of Practice.
- CLEANING – To clean, simply use a cloth dampened with water only. Cleaning agents are not recommended as their use may harm the product
and void warranty claims.
Fitting Instructions Cover Removal
1. Modular accessories can be wired before or after clipping into
the frame.
2. Once the module is rmly clipped to the frame the cover can be
clipped into place.
To remove cover insert a at blade screwdriver between cover and
frame tab and gently lever apart.
Module Removal
To remove modules use ejector tool (40MET) as shown below.
Ejector
Tool
Module
Releases
in this
Direction
Detail A
Ejector tool must be pushed in straight down and not wiggled.
Product Catalogue 2012
70
S3000