C-Bus Two Channel Infrared Transmitter Unit Installation Instructions 5034NIRT Series REGISTERED DESIGN REGISTERED PATENT
Intelligent Building Series C-Bus Infrared Transmitter Installation Instructions Table of Contents Section..................................................................................................... Page 1.0 Product Range ........................................................................................3 2.0 Description ..............................................................................................3 3.0 Installation Instructions................................................
Intelligent Building Series C-Bus Infrared Transmitter Installation Instructions 1.
Intelligent Building Series C-Bus Infrared Transmitter Installation Instructions 3.0 Installation Instructions A typical installation of the 5034NIRT C-Bus Infrared Transmitter is shown below: 3.1 Mounting Considerations • The E5034NIRT Unit is a British Standard Wall Plate, and may only be mounted using deep style wall boxes (Clipsal Catalogue Number E157). Do not use the shallow wall box (E157S).
Intelligent Building Series C-Bus Infrared Transmitter Installation Instructions 3.3 Connection to the C-Bus Network Installation requires connection to the unshielded twisted pair C-Bus Network Cable. The illustration below shows the recommended technique for cable termination giving the best electrical performance. It is required that Category 5 data cable is used, Clipsal catalogue number 5005C305B. The C-Bus Network connection is polarity sensitive, and is clearly marked on the rear of the Unit.
Intelligent Building Series C-Bus Infrared Transmitter Installation Instructions 3.4 High Speed Serial Connection The 5034NIRT Infrared Transmitter Unit requires programming and configuration. This can be achieved over the existing C-Bus Network cabling (via a PC Interface), however download times may be excessive (approx 15 minutes maximum for full configuration download).
Intelligent Building Series C-Bus Infrared Transmitter Installation Instructions Note: Care must be taken when using the 5100HSC High Speed Serial Cable. Please note the following recommendations: • • • • The 5100HSC High Speed Serial Cable contains custom electronics (I2C), and is approximately 1 metre in length. Do not attempt to extend the length of this pre-terminated cable. If additional distance is required then use an RS232 extension lead (maximum recommended length 20m).
Intelligent Building Series C-Bus Infrared Transmitter Installation Instructions 5.0 C-Bus System Clock The Infrared Transmitter Unit incorporates a software selectable C-Bus System Clock used for synchronising data communications waveforms on the C-Bus Network. This feature may be enabled using the C-Bus Installation Software. At least one C-Bus System Clock is required to be active for successful Network communications.
Intelligent Building Series C-Bus Infrared Transmitter Installation Instructions 9.0 Power Surges and Short Circuit Conditions The C-Bus Infrared Transmitter Unit is not directly connected to mains, however the mains voltage which is used to supply power to the C-Bus Network must be limited to the range specified. Each Unit incorporates transient protection circuitry and additional external power surge protection devices should be used to enhance system immunity to power surges.
Intelligent Building Series C-Bus Infrared Transmitter Installation Instructions 12.0 Programming Requirements The 5034NIRT C-Bus Infrared Transmitter Unit requires programming in order to operate correctly: 12.1 Programming C-Bus Operating Parameters The C-Bus Infrared Transmitter Unit must be programmed to set a unique identification (Unit Address) and the mode of operation on the C-Bus Network. C-Bus Installation Software v2.3.0 (or higher).
Intelligent Building Series 13.0 C-Bus Infrared Transmitter Installation Instructions Electrical Specifications Catalogue No.
Further Information For further information about configuring this product and other C-Bus devices, please consult the documentation supplied. Further assistance can be obtained as follows: • C-Bus Manuals The 5000M/2 C-Bus Technical Manual provides a comprehensive and definitive guide to Clipsal C-Bus. Includes hardware and software specifications, product datasheets, system design and installation guides, and software overview with fully worked programming examples.
