Technical Specifications

ManualsBrandsClipStone ManualsBuilding materials9 in. x 4 in. Manufactured Stone Prostack Sand Corner Siding (4 ft. Pack)

SPECIFICATION GUIDELINE

SECTION 04700 - Simulated masonry

(Manufactured stone veneer and

t r i m )

Environmental StoneWorks specification guideline should be used to assist design professionals in the preparation of projects.

Edit and delete items that may not be applicable. Verify all referenced section numbers / titles.

SECTION 04730 - Simulated Stone

(Manufactured stone veneer and trim)

PART 1 - GENERAL

1.1

Summary of content (6 pages)

PAGE 1
SPECIFICATION GUIDELINE SECTION 04700 - Simulated masonry (Manufactured stone veneer and trim) Environmental StoneWorks specification guideline should be used to assist design professionals in the preparation of projects. Edit and delete items that may not be applicable. Verify all referenced section numbers / titles. SECTION 04730 - Simulated Stone (Manufactured stone veneer and trim) PART 1 - GENERAL 1.1 Related documents A.
PAGE 2
SPECIFICATION GUIDELINE SECTION 04700 - Simulated masonry 1.3 REFERENCES (con’d) (Manufactured stone veneer and trim) RILEM 11.4 – Measurement of Water Absorption Under Low Pressure. UL 723 – Standard for Safety for Surface Burning Characteristics of Building Materials. A Building Code Compliance: 1. The International Association of Plumbing and Mechanical Officials (IAPMO) B. Masonry Veneer Manufacturers Association (MVMA) 1.4 SUBMITTALS A. B. C. D. E. F. G. H. I. J. K.
PAGE 3
SPECIFICATION GUIDELINE SECTION 04700 - Simulated masonry (Manufactured stone veneer and trim) 1.5 QUALITY ASSURANCE (con’d) C. Manufacturer Qualifications: ClipStone… 1. has over 35 years’ experience in producing simulated masonry. 2. provides field service representative. 3. has IAMPO certification. 4. has a 50 year product warranty. 5. is in good standing with the MVMA. D. Installer Qualifications: Environmental StoneWorks… 1.
PAGE 4
SPECIFICATION GUIDELINE SECTION 04700 - Simulated masonry (Manufactured stone veneer and trim) 1.7 SITE CONDITIONS A. Environmental Site Conditions: Comply with ClipStone Installation Procedures for environmental conditions. PART 2 - PRODUCTS 2.1 MANUFACTURER ClipStone stone veneer is a precast concrete product engineered from Portland cement, light weight aggregates, mineral oxide, and chemical additives to resemble natural stone in both texture and color.
PAGE 5
SPECIFICATION GUIDELINE SECTION 04700 - Simulated masonry (Manufactured stone veneer and felt paper or 1 layer and a thouse-wrap product supported by a current evaluation report showing rim) equivalency to Grade D building paper. Install weather resistive barrier (per manufacturer’s instructions) over all exterior surfaces designated to receive stone veneer and require waterproofing. WRB shall be applied horizontally with the upper layer lapped over the lower layer at not less than 2”.
PAGE 6
SPECIFICATION GUIDELINE SECTION 04700 - Simulated masonry (Manufactured stone veneer and 2. Corners: Provide ClipStone corner units. t r pre-manufactured im) E. Cleaning: 1. Clean stone veneer in accordance with ClipStone Installation Procedures.