Instruction manual

Linddana A/S, Ølholm Bygade 70, DK-7160 Tørring, Telephone [phone] Fax [phone]
Instructions: TP 150-200-250 dated 05.12.2005
 Copyright 2001
3
TECHNICAL DATA:
Type
150 PH 200 PH 250 PH
Operating principle Disc chipper
Rotor disc diameter 660 mm 760 mm 960 mm
Speed of PTO r/min 540-1000 540-1000 540-1000
No. of knives 2 3 3
Power requirement min./max. 20-60 hp 40-80 hp 50-120 hp
Tree stem diameter, max. 150 mm 200 mm 250 mm
Chip length 8 mm 10 mm 13 mm
Weight 490 kg 700 kg 1050 kg
Type
150 PHM 200 D/VHM 250 PHM
Operating principle Disc chipper
Rotor disc diameter 660 mm 760 mm 960 mm
Speed of PTO r/min 1250 1000 925
No. of knives 2 3 3
Power requirement 27 hp 52 hp 72 hp
Tree stem diameter, max. 150 mm 200 mm 250 mm
Chip length 8 mm 10 mm 13 mm
Weight 800 kg 1350 kg 2250 kg
APPLICATION
The machine is intended for stationary applications and is designed specially for chipping wood in the
form of stems, branches, bushes, waste from hedges, etc.
The tractor or trailer to which the wood chipper is connected must be securely braked during operation.
The machine must not: be used for materials other than wood,
be used to move trees, stumps, etc.
Clearance chains, axes, motor saws, etc. must not be allowed in the feed funnel.
Foreign matter such as stone, iron and other metals must not be allowed to enter the wood chipper since it
will damage the knives and anvils, and could present a serious hazard for persons in the vicinity of the
machine.
Before starting up the wood chipper, check to make sure that there is no foreign matter inside the
machine. Remove the bolts holding the upper and lower parts of the rotor housing together. Lift the upper
part until the ejector spout rests in its own position and turn the rotor a few times manually.
The knives are set permanently to give the following chip lengths: 8 mm in TP 150, 10 mm in TP 200 and
13 mm in TP 250.
All nuts and bolts used have metric threads.
PTO (Power Take-Off shaft) 150 series : Walterscheid 2300 with freewheel
200 series : Walterscheid 2400 with freewheel
250 series : Walterscheid 2400 with freewheel and friction clutch
The right to make changes in design and specifications without notice is reserved.