Instruction manual

Linddana A/S, Ølholm Bygade 70, DK-7160 Tørring, Telephone [phone] Fax [phone]
Instructions: TP 150-200-250 dated 05.12.2005
 Copyright 2001
7
KNIFE REPLACEMENT
Bolts per knife / total M12x30-10.9 DIN 933 Unbrako
type MK
M12x45-12.9 DIN 7991 Unbrako type MK M12x50-12.9 DIN 7991 Unbrako type MK M12x55-12.9 DIN 7991 Flange nuts M12 DIN 6331-10 Tightening torque Max. [Nm / KPm]
TP 150 3/6 X 0 110 Nm / 11 KPm
TP 200 w/out sliver breaker 4/12 X 12 95 Nm / 9.5 KPm
TP 200 w/sliver breaker 4/12 X 12 95 Nm / 9.5 KPm
TP 250 w/out sliver breaker 5/15 X 15 95 Nm / 9.5 KPm
TP 250 w/sliver breaker 5/15 X 15 95 Nm / 9.5 KPm
Important!
Carefully clean the rotor disc and the bolting surfaces of knives before mounting.
When fitting, bolts must be lightly oiled (µ=0.125), i.e. with thin oil, spray oil or similar.
Copper grease, MoS
2
, or corresponding low-friction grease must not be used.
Use only ORIGINAL BOLTS
Only Unbrako countersunk bolts may be used!
Bolt life = Knife life
For safety reasons it is important that bolts be changed regularly at intervals corresponding to the life of a
set of knives. Therefore when new knives are purchased, new bolts and nuts are also supplied.
To ensure good chip quality it is important that knives and anvils remain sharp and intact. Daily
inspection is strongly recommended.