User Manual

Programming wireless and non wireless microphone bases
Listed below are shown all the programmes used to cover the many models used for
both wireless and non wireless microphone bases. Some of the options shown may
not be applicable to your model and cannot be programmed.
Latching / Normally off (Press touch switch for microphone to be Live)
This option will allow the microphone to be live when the touch switch is pressed.
Press touch switch again to mute the microphone.
Note: It’s important to ensure that any touch switch input operations are made within
2 seconds after seeing either slow or rapid flashing of the led indicator. Failure to do
so will prevent the correct programming taking place. Simply switch the power off for
5 seconds and start again.
Setting Programme mode
Press and hold down the touch switch and at same time slide the power
switch to its on position then immediately release the touch switch. The
red led will rapidly flash. If it does not then switch power off and wait a few
seconds then try again. Do not proceed until you see rapid flashing of the
led.
Changing the Programme
After the red led stops rapidly flashing press the touch switch once and wait
for the led to flash then press the touch switch twice and wait for led to flash
then wait for led to rapidly flash. Now press twice and wait for flash then
press once and wait for flash then wait for rapid flashing. Wait a further 15
seconds to allow the new data to be programmed into the processor. The
wireless base has now been set to latching / normally off and can now be
used.
Easy programme steps
 Set programme mode as detailed above (identified by rapid flashing)
 Press once and wait for flash.
 Press twice and wait for flash followed by rapid flashing.
 Press twice and wait for flash
 Press once and wait for flash followed by rapid flashing then wait 15
seconds before using.