Owner manual

ManualsBrandsClock Audio ManualsMicrophonesSM 80S-RF

SM 80S-RF

Switch connections

Cable colour

Function

RJ 45 Pin number

Red

Red LED

Blue

-ve switch

Brown

+ve 12/24V dc switch

Yellow

Switch Logic control

Green

Green LED

PROFESSIONAL MICROPHONE SYSTEMS

A low profile through table shock mount microphone base fitted with a flip cover to conceal the

connector when closed.

www.clockaudio.com

• Designed for remote switching.

• Low profile table mounted microphone base.

• Requires a minimum table thickness of 25mm (1”)

• Includes a concealed flap to allow the table to be

used for other purposes.

• Built in shock mount to eliminate surface bound

noise.

• Fitted with momentry (PTT) or latching switch.

• Bi-colour common anode LED to confirm status

• Housing PPA-RF for use with Clockaudio mics C

3100, C 310R, C 313/SR, C 314/SR.

• Terminated with RJ 45 connector and supplied

with RJ 45 coupler which allows connection via RJ

12 or RJ 45 plug back to dsp.

Applicable for Clockaudio microphones only

3 Pin Tini Q Wiring 3 Pin Male XLR Wiring

PIN 1 Phase – PIN 1 Ground

PIN 2 Phase + PIN 2 Phase +

PIN 3 Ground PIN 3 Phase -

Architects and Engineers Specifications for

Microphone Shock Mount SM 80S-RF

It shall come complete with a dedicated phantom

power adaptor designed to power the C 3100

miniature gooseneck microphones terminated with

Tini Q 3 pin connectors. The Phantom power adaptor

shall accept 9 to 48 volts DC and have impedance of

200 ohms. The phantom power adaptor shall also

include filters, which shall eliminate all GSM

frequencies from 800-1200 MHz and be terminated

with a male 3 pin XLR. The microphone shock mount

shall be available in satin Nickel or Black Nextel

finishes. The through table microphone shock mount

shall be a Clockaudio SM 80S-RF.

Summary of content (2 pages)

PAGE 1
SM 80S-RF PROFESSIONAL MICROPHONE SYSTEMS A low profile through table shock mount microphone base fitted with a flip cover to conceal the connector when closed. • • • • • • • • • Designed for remote switching. Low profile table mounted microphone base. Requires a minimum table thickness of 25mm (1”) Includes a concealed flap to allow the table to be used for other purposes. Built in shock mount to eliminate surface bound noise. Fitted with momentry (PTT) or latching switch.
PAGE 2
SM 80S-RF Installation guide 1) Ensure minimum table thickness of 25mm (1”). 2) Drill a 50mm (2”) hole through the table see fig A. 3) Remove the 3 M3 pan headed screws from the bottom plate see fig B. 4) Remove the 2 M3 x 30mm pan headed screws securing the base plate to the top assembly see fig C 5) Select the LED voltage by moving the jumper to the required position see fig D. 6) Fit the top assembly through the 50mm (2”) hole see fig E.