Installation Guide

ASSEMBLY INSTRUCTIONS FOR
SPRING LATCHES AND STRIKER
PLATES
NOTE: If door is equipped with an automatic
garage door opener, the spring latches and striker
plates should not be installed.
Step 1
Attach the striker plate (1) to the track using two ¼”
x 5/8” track bolts (2) and two ¼” flange nuts (3).
Insert blots through the two 9/32” holes located top
and bottom of the large knock-out. NOTE: Be sure
the striker plate wraps around the back of the track as
shown. Do not tighten (FIG. 3)
Step 2
Place the spring latch (4) on the end stile of the door
section and align the spring latch with the striker and
the holes in the stile. Secure using two #1 x 5/8”
sheet metal screws (5). Make sure that the striker fits
around the spring latch and secure in place.
For Lock Cables
NOTE: If the lock is located in the center of the
door width, cut lock cable (6) in half and go to Step
3.
Step 1
Rotate the inside release handle counter clockwise
until it stops. Measure from the top left hole in the
handle to the end of the left spring latch.
Step 2
Take the lock cable (6) and, using the measurement
just obtained, measure from the inside of the cable
stop (7) and cut cable.
Step 3
Thread the cable through the left hole in the top of
the inside release handle from the underside until the
stop button comes into contact with the handle.
Extend the cable to the left spring latch and feed the
end of the cable into the hole as shown, and secure in
place with one ¼” x 5/8” track bolt (2) and ¼” nut
(3).
NOTE:
Be sure to pull cable taut before securing in
place.
Step 4
Repeat for other side using the remaining cable and
the right hole on the lower part of the handle. Some
torsion spring doors can have one cable.
Left Side Shown (Repeat for Right Side)
¼” - 20 x 5/8” Track Bolt
¼” - 20 x Hex Washer Head Nut
Spring Latch
Lock Cable (To Be Cut)
Cable Stop (Pre-Attached)
26
36
42
54
61
Vertical Track
Door
End Stile
Inside Release Handle
NO.
QTY
DESCRIPTION
QUANTITÉ
DESCRIPTION
Nº
CANT.
N°
DESCRIPCIÓN
Raildeguidagevertical
Porte
Rielvertical
Puerta
Poignéededéverrouillageintérieure
Montantd'extrémité
Manijadeliberacióninterior
Montantedeextremo
FIGURE 3
FIGURA 3
12
Striker Plate
Gâche
Placadecerrojo
Boulonderaildeguidage¼po‐20x5/8po
Pernoderielde¼”‐20x5/8”
Écrouàtêteàembasehexagonale¼po‐20x
Tuercaconcab ezadearandelahexagonal¼”‐20
Loquetàressort
Cerraduraderesorte
#14 x 5/8” Sheet Metal Screw
Visautotaraudeusesn°14x5/8po
TornillosparaláminademetalNº14x5/8
Câbledeverrouillage(àcouper)
Cabledebloqueo(parasercortado)
7
2
Butéedecâble(préfixée)
Topedeparadadelcable(prefijado)
Côtégaucheillustré(répétezpourlecôtédroit)
Seilustraelladoizquierdo(repitaparaelderecho)