SDS

SECTION 5 - PHYSICAL HAZARDS (REACTIVITY DATA)
SECTION 6 - HEALTH HAZARDS
SECTION 7 -SPECIAL PRECAUTION AND SPILL/LEAK PROCEDURES
SECTION 8 - SPECIAL PROTECTION INFORMATION/CONTROL MEASURES
Stability Unstable
Stable
Conditions
to Avoid
Incompatability
(Materials to Avoid
2. Chronic
1. Acute
Signs and
Sympton of Exposure
Medical Condition Generally
Aggravated by Exposure
Chemical Listed as Carcinogen
or Potential Carcinogen
National Toxicology
Program
OSHA
Ye s
No
Ye s
No
Ye s
No
I.A.R.C.
Monographs
Emergency and
First Aid Procedures
ROUTES
OF
ENTRY
1. Inhalation
2. Eyes
3. Skin
4. Ingestion
Precautions to be Taken
in Handling and Storage
Other
Precautions
Steps to be Taken in Case
Material is Released or Spilled
Waste Disposal
Methods (Consult federal, state, and local regulations)
Respiratory Protection
(Specify Type)
Other
SpecialMechanical
(General)
Local
Exhaust
Ventilation
Other Protective
Clothing or Equipment
Protective
Gloves
Eye
Protection
Work/Hygienic Practices
Safety glasses recommeneded
Do not contaminate smoking materials; wash hands and/or contaminated area after exposure.
Recommended
Recommended
Plastic disposable
Not required unless product is being used in an enclosed area.
Plastic apron, fabric laboratory coat recommended.
Use reasonable care. Do not store above 120ºF or near flammables.
Dispose of in accordance with current Federal, State, and Local Regulations.
X
XX
X
Oxidizing material can cause a reaction
None
Wipe off and wash with soap and water.
Give milk or water; do not induce vomiting; consult physician.
Flush with water, get medical attention.
Remove to fresh air, if necessary seek medical attention.
Scrape up with proper tools; wipe up with absorbant cloth or paper towel; apply non-skid absorbant material to floor. Collect
Strong Oxidizers, temperatures above 500ºF
None
Avoid spills; causes slippery surfaces.
waste materials for salvage or disposal.
PRO LUBE Synthetic Spray Lubricants
Prolonged and repeated contact with skin may cause skin irritation.
No known medical condition that might be aggravated by exposure.
Skin contact: Wipe off and wash with soap and water.
Toxic vapors may evolve above 550ºF; provide adequate ventilation if used above this temperature.
Recommended
Hazardous
Decomposition Products
Hazardous
polymerization
May Cccur
Will Not Occur
X
Fluorine products, silicon dioxide, CO , traces of incompletely burned carbon.
2
SECTION 9 - REGULATORY INFORMATION
D.O.T. REGULATIONS: ORM-D
NFPA30: Class 3 Aerosol
SECTION 10 - DISCLAIMER
The information contained herein is presented in good faith and is considered to be accurate. However, no warranty is expressed or implied regarding
the accuracy of the data or the results to be obtained from the use, thereof. Because the information contained herein may be applied under condi-
tions beyond our control, we assume no responsibility for its use.