Specification

G01-R01-0704
• You can install your new garage door yourself IF…
a) you have help (it may weigh up to 500 lbs.);
b) you have the right tools and reasonable mechanical
aptitude or experience; and
c) you follow these instructions very carefully.
• Garage doors use springs to balance them. There are
two types of springs installed — extension or torsion.
Each of these is available in either a standard or EZ-Set
TM
assembly option. Please look at the drawings on page 8 to
see which springs your old door has.
• If your old door uses torsion springs, do not attempt
to remove the door or the springs yourself. Have a
qualied door repair service remove them. Attempting to
remove a torsion spring assembly without proper training
or tools may result in an uncontrolled release of spring
forces which can cause serious or fatal injury.
• Only the track specied and supplied with the door
should be used.
• The brackets at the bottom corners of your garage door
are under great tension. Do not attempt to loosen any
bracket fasteners except when and as directed in
detail in the following instructions. Otherwise, the
bracket could spring out with dangerous force.
• Do not permit children to play beneath or with any
garage door or electric operating controls.
• In removing a garage door that has extension springs,
follow the instructions carefully, including the use of “C”
clamps or locking pliers on both sides of the door in
order to keep the door from moving once the springs are
removed.
• Keep hands and ngers clear of section joints, track, and
other door parts when the door is opening and closing to
avoid injury. The lift handles are located for safe operation
as well as easy use.
• Bolts must be installed at the rear end of horizontal tracks.
These act to stop the rollers and keep the door from rolling
off the back of the track.
• Track installations must use sway braces on the rear track
hangers to prevent sideways movement. If the tracks are
not rmly stabilized they might spread, allowing the door
to fall and cause severe injury and damage.
• Springs, cables, and bottom xtures are under strong
spring tension. Do not attempt to loosen any fasteners
on these components. You could suddenly release
spring forces and risk severe injury.
• If the garage door and/or any of the supporting track
are damaged, operating the door could be hazardous.
Call an authorized representative of the manufacturer or
professional door repair service promptly.
• If repairs are ever required to your door, safety and
trouble-free operation can be best assured by using
original replacement parts.
• Once you have completed the installation of your new
garage door, please be sure that your garage complies
with all applicable ventilation requirements before you
enclose any vehicles in the garage. Good ventilation
avoids re and health hazards caused by fumes
accumulating within a well-sealed garage.
• Clopay Building Products Company disclaims all liability
for any installation that is not in compliance with applicable
state or county building codes.
• Doors equipped with automatic door operators can
cause serious injury or death if not properly adjusted and
operated. To ensure safety of these doors:
a) test the sensitivity of the operator’s safety reverse
mechanism monthly;
b) if your door has a pull down rope, you must remove
the pull down rope;
c) make sure the door remains unlocked;
d) do not allow children to play with the controls.
STEP 2 – READ THIS SAFETY INFORMATION
IMPORTANT!
To Protect Yourself From Injury You Must Carefully Read The Following Safety
Information and Warnings Before You Install Or Use Your New Garage Door
WARNING
In the interest of safety this symbol means WARNING or
CAUTION. Personal injury and/or property damage may
occur unless instructions are followed carefully.
4