User Manual

Performance of your Jump-N-Carry

will depend upon several factors:

•Agood, solid connection between the Jump-N-Carry

clamps and the battery

and ground connections are a must. Moving the jumper cable clamps back and

forth while clamping will help create a better connection.

• Clean connections between your vehicle or equipment battery and its terminals

are very important. For an optimal connection, corrosion (soft grayish-white

build-up) upon battery terminals must be removed. With the ignition turned off,

disconnect the battery cables and clean the terminals and battery posts with a

baking soda solution.

• All batteries are affected by temperature changes, and the Jump-N-Carry

’s

small, lightweight battery is more sensitive to storage temperature than a stan-

dard automotive battery. Temperatures above 20º C will improve amperage out-

put, while temperatures below 20º C decrease amperage output. The ideal stor-

age environment for emergency use is at room temperature.

LED Indicators – MODEL 300 ONLY

To check the battery state of charge, press the red status button.

•AGood Green LED indicator only means the unit is ready to go.

•AGood Green LED and Recharge Red LED indicates the unit is low.

•ARecharge Red LED indicates the unit should be recharged before use.

•ACharging Red LED indicates the unit is charging and the AC charger

is working.

Battery Status Gauge – MODELS 400, 660, 950 & 4000

Press the red push-button to momentarily turn the gauge on.

• The Green shaded indicator bar indicates the unit is capable of jump-starting.

• The Yellow shaded indicator bar indicates the unit needs to be recharged.

• The Red shaded indicator bar indicates the unit must be recharged

before use.

Battery Status Gauge – MODEL 12/24

Press the red push-button to momentarily turn the gauge on. The gauge is an approximate

indicator of the battery's state of charge. When fully charged, the gauge should read 13 volts

or more when the unit is in the 12-volt mode, and 26 volts or more in the 24-volt mode.

12 Volt DC Accessory Outlet – MODELS 400, 660, 950, 4000 & 12/24 ONLY

Jump-N-Carry

is equipped with a standard 12 volt DC receptacle. Plug any accessory

up to 12 Amps into the socket and Jump-N-Carry

will provide power. If the amperage rat-

ing is exceeded, a built-in auto-reset circuit breaker automatically shuts power off until the

accessory, or overload source, is removed. Under extreme power usage, recharge the unit

for 36-48 hours.

Battery Status Panel

Performance and Temperature

12 Volt DC Power