User Manual

ManualsBrandsClore Automotive ManualsAutomotiveJump-N-Carry JNC1224 3400/1700 Peak Amp 12/24V Jump Starter

RECHARGING USING AC POWER

Jump-N-Carry

300 Only:

The Jump-N-Carry

300 comes with a separate wall-mount charger.

1) Plug the charger cord into the recharge jack on the front of the unit, then plug into

a 120 VAC outlet.

2) The red Charging LED will illuminate while the charger is plugged into AC power to

indicate the unit is charging.

Jump-N-Carry

400, 660 & 4000 Only:

The Jump-N-Carry

400, 660 & 4000 require a household extension cord (not included).

1) Plug the female end of the extension cord into the charger plug on the front of the

unit. The charger plug has 2 blades and resembles a standard household plug that

would fit into a 120 VAC wall receptacle.

2) Plug the male end of the extension cord into a 120 VAC outlet.

NOTE: We do not recommend charging Jump-N-Carry

models 300, 400, 660, 950 or

4000 for more than 24 hours under normal usage. However, under extreme usage or high

discharge situations, recharge the unit for 36-48 hours.

Jump-N-Carry

950 and 12/24 Only:

The Jump-N-Carry

950 and 12/24 unit is equipped with a special automatic battery

charger that can be continually plugged into the unit and AC power. The automatic battery

charger is mounted under the front access plate.

1) Plug the end of the charging cord (part # 310241, included) into the charger recep-

tacle on the front of the unit.

2) Plug the male end of the charging cord into any 120 VAC outlet.

Charge the unit for the recommended amount of time for your unit, as indicated on the chart

below. Once the time has expired, check the battery charging status (see Battery Status

Panel section on page 4) to ensure charging is complete.

Recharging Jump-N-Carry

MODEL

300

400, 660 &

4000

950 & 12/24

AFTER A SINGLE

JUMP-START

1 hour

AFTER MULTIPLE

JUMP-STARTS

12 hours or overnight

AFTER USING AS

PORTABLE POWER

24-36 hours

These units are equipped with an automatic charger. Keep the unit

plugged in when not in use.

RECHARGING USING 12 VOLT POWER (requires optional accessory)

Jump-N-Carry

(models 400, 660, 950, 4000 and 12/24 only) may be recharged by

using an optional accessory cord with two male ends (see Optional Accessories section).

Plug one end into the Jump-N-Carry

’s 12V outlet and the other end into the vehicle’s

12V power port socket. The vehicle must be running to charge with this method.

NOTE: To recharge both batteries on the Jump-N-Carry

12/24, the 12 volt connector

must be plugged into the 12 volt side.

Suggested recharge times when using 12 volt power are:

• 20 minutes when the unit is used for jump-starting.

•2 hours when the unit is used for portable power.

•5 hours under very high discharge conditions.

SUGGESTED RECHARGE TIMES