User Manual

6
Jump-N-Carry
®
may be stored virtually anywhere, and in any position. However, take pre-
cautions to ensure that the positive and negative clamps do not come into contact with each
other or a common metal surface. We recommend storing the Jump-N-Carry
®
in the box in
which it was received.
This unit contains a sealed non-spillable lead acid battery. The battery must be recycled.
Store in a cool, dry area.
The Jump-N-Carry
®
battery may be removed by unscrewing the perimeter screws on the
back cover. Disconnect the wires from the battery terminals. Note the position of the battery
and wire locations.
•2 wire connections go to each terminal.
• The small wires are color coded red for positive and black for negative.
• The large cable is identified by the color of the clamp attached to the cable, red is posi-
tive and black is negative.
Caution: It is possible the cables could become crossed inside of the case when the
battery is removed. The cables always travel straight to the battery terminals and should
never cross each other.
• All red wires (red clamp) attach to the positive side of the battery. All black wires (black
clamp) attach to the negative side of the battery.
•To connect a new battery, slide the battery fully into the case. Note the color of the wires
and match the color to the battery terminals.
• Replace the 6 or 8 perimeter screws on the back cover.
• Charge the new battery for 12 hours before use or storage.
(FOR MODELS 400, 660, 950, 4000, & 12/24 ONLY)
Though your new Jump-N-Carry
®
can already power almost any 12 volt DC accessory you
use in your car, RV or boat, shown below are two optional accessories that expand the
versatility of your Jump-N-Carry
®
.
AC POWER INVERTER: Household power from your portable jump-starter
Use the portable power outlet for power outages, fishing and camping trips, extended run-
ning time for camcorders, computers, and more. With the optional AC Power Inverter, the
uses of Jump-N-Carry
®
are unlimited! The inverter uses the DC battery power of your jump
starter to make 110/120 V AC power, and is equipped with standard household receptacle
outlets.
MALE-MALE POWER CORD
Allows the unit to be recharged from a vehicle’s 12 volt power port.
DC TO AC INVERTER
Optional Male-Male
Cord allows unit to be
recharged from vehicle
Optional AC
Power Inverter
from standard
household outlets
Storage
Battery Replacement
Optional Accessories