SAFETY DATA SHEET Issuing Date January 5, 2015 Revision Date New Revision Number 0 1.
Tilex® Mold & Mildew Remover Revision Date New GHS Label elements, including precautionary statements Emergency Overview Signal word Warning Hazard Statements Causes mild skin irritation Causes serious eye irritation Appearance Clear, pale yellow Physical State Liquid Odor Herbaceous, marine, bleach Precautionary Statements - Prevention Wash hands and any exposed skin thoroughly after handling. Wear eye protection/face protection such as safety glasses.
Tilex® Mold & Mildew Remover Revision Date New 4. FIRST AID MEASURES First aid measures General Advice Show this safety data sheet to the doctor in attendance. Eye Contact Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Keep eye wide open while rinsing. Do not rub affected area. Get medical attention if irritation develops and persists. Skin Contact Take off contaminated clothing.
Tilex® Mold & Mildew Remover Revision Date New 6. ACCIDENTAL RELEASE MEASURES Personal precautions, protective equipment and emergency procedures Personal Precautions Avoid contact with eyes, skin, and clothing. Use personal protective equipment as required. Other Information Refer to protective measures listed in Sections 7 and 8. Environmental precautions Environmental Precautions See Section 12 for ecological Information.
Tilex® Mold & Mildew Remover Revision Date New Individual protection measures, such as personal protective equipment Eye/Face Protection If splashes are likely to occur: Wear safety glasses with side shields (or goggles). None required for consumer use. Skin and Body Protection Wear protective gloves and protective clothing. Respiratory Protection If exposure limits are exceeded or irritation is experienced, NIOSH/MSHA approved respiratory protection should be worn.
Tilex® Mold & Mildew Remover Revision Date New 10. STABILITY AND REACTIVITY Reactivity Reacts with other household chemicals such as products containing ammonia, toilet bowl cleaners, rust removers, vinegar, or acids to produce hazardous gases, such as chlorine and other chlorinated compounds. Chemical stability Stable under recommended storage conditions. Possibility of Hazardous Reactions None under normal processing. Conditions to avoid None known based on information supplied.
Tilex® Mold & Mildew Remover Carcinogenicity Revision Date New The table below indicates whether each agency has listed any ingredient as a carcinogen. Chemical Name ACGIH Sodium hypochlorite 7681-52-9 IARC (International Agency for Research on Cancer) Group 3 - Not Classifiable as to Carcinogenicity in Humans IARC NTP OSHA Group 3 - - Reproductive Toxicity No information available. STOT - single exposure No information available.
Tilex® Mold & Mildew Remover ICAO UN-No Proper Shipping Name Hazard Class Packing Group Description IATA UN-No Proper Shipping Name Hazard Class Packing Group Description IMDG/IMO UN-No Proper Shipping Name Hazard Class Packing Group EmS No. Marine Pollutant Description Revision Date New UN3082 ENVIRONMENTALLY HAZARDOUS SUBSTANCE, LIQUID, N.O.S. 9 III UN3082, ENVIRONMENTALLY HAZARDOUS SUBSTANCE, LIQUID, N.O.S. (SODIUM HYPOCHLORITE), 9, III UN3082 ENVIRONMENTALLY HAZARDOUS SUBSTANCE, LIQUID, N.O.S.
Tilex® Mold & Mildew Remover Revision Date New Clean Water Act This product contains the following substances which are regulated pollutants pursuant to the Clean Water Act (40 CFR 122.21 and 40 CFR 122.
Tilex® Mold & Mildew Remover Revision Date New 16. OTHER INFORMATION NFPA Health Hazard 2 Flammability 0 Instability 0 Physical and Chemical Hazards - HMIS Health Hazard 2 Flammability 0 Physical Hazard 0 Personal Protection B Prepared By Product Stewardship 23 British American Blvd. Latham, NY 12110 1-800-572-6501 Revision Date New Revision Note New Reference 1062754/50049006.