Instructions / Assembly

ManualsBrandsCLOSETMAID ManualsCloset Storage & Organization12 in. White Steel Shelf Bracket for Wire Shelving

ShelfTrack

Installation Tips

1. Use the correct hardware

Select the hardware that is right for your wall type:

2. Hang track location

Track can be installed at any height. However, for maximum

adjustability and strongest installation, install track ﬂush to

ceiling and screw into wood header behind wallboard. Stud

installation is recommended whenever possible for the strongest

installation.

3. Determine length and spacing of standards

Standards are available in several lengths, depending on the number

of shelves you want and the spacing between the shelves. The closer the

standards are placed together, the stronger the installation. Standards

should be spaced no more than 24 in. apart, and no more than 4 in.

from the end of the shelf.

4. Securing standards

Each standard must be secured to the wall with one screw at the closest

hole to the center of the standards. When using toggle bolts, remove

toggle, put bolt through standard and re-attach toggle to bolt before

placing standard on track.

5. Attaching brackets

Attach brackets at desired shelf height.

NOTE: Always match bracket size to shelving depth except when using

Shelf & Rod shelving. Always use 12 in. brackets for this type of shelving. When

installing 16 in. SuperSlide

with Closet Rod & Support always use 12 in. brackets.

6. Cutting shelving, closet rods, and hang tracks

Wire shelving can be cut using a bolt cutter or hacksaw.

Closet rods can be cut using a pipe cutter (recommended) or a

hacksaw. Hang tracks can be cut with a hacksaw.

7. Corners

When two shelves come together in a corner, use a corner shelf support

to connect them. Use a corner closet rod to allow clothes to slide

uninterrupted around corners.

NOTE: SuperSlide

Closet rod supports should be placed where closet rods join.

8. End caps

Add caps to every exposed wire on both ends of each

shelf and to the ends of closet rods. End caps protect

you, your clothing and the shelving materials.

with

A D

B E

C F

Hang Track

Standard

Bracket

Closet Rod

Closet Rod Support

Closet Rod End Cap

Shelf End Cap

Choose Your Hardware

Drywall

Drill 1/2 in. holes and

secure to the wall with

toggle bolts.

Studs

Secure to the wall with #12

x 2 in. pan head screws at

stud locations.

Concrete

Drill 1/4 in. holes. insert

#12 wall anchors and

secure to the wall with #12

x 2 in. pan head screws.

24 in. maximum

24in.

61cm

ClosetMaid.com | 1-800-874-0008 | 10/13