Laminate Installation Tips 8/14 Tools you will need for assembly: .25 in. .50 in. © ClosetMaid Corporation 2014 | Ocala, FL 34471 | 1-800-874-0008 | www.closetmaid.com | www.closetmaid.
Getting Started • Please refer to the instruction sheet provided in the product package for the specifics on required & recommended tools and the assembling the products. • Take an inventory of the parts for the products purchased to insure you have everything you need for the installation. • Pre-plan the placement of the towers and closet rods in your cleaned out closet. General Tips • The recommended depth for reach-in closets is 30 in.
1 Tower in center with hang rods on the left and right and build your towers first. A) Assemble Place your towers in the closet. which side you want the long hang B) Choose and the double hang to be, as you may want a wider width of double hang. the length that the rods will need C) Measure to be for each side. Make sure that the span between units or unit and wall is not greater than 48 in.
2 Tower on left of closet – closet rods to the right and build your towers first. A) Assemble Position the tower to the left of the closet. attaching the tower to the wall make B) Before sure the closet walls or doors do not block access to the tower. Standard towers are 14.5 in. up to 16 in. deep and Hutch style towers are up to 20 in. deep. the Tower to the wall. Choose whether C) Attach you want the long hang or the double hang for the right hand side.
3 Corner unit in left corner and Tower on right, hang in center and build your A) Assemble corner unit and towers first. attaching the tower to the wall B) Before make sure the closet walls or doors do not block access to the tower. Standard towers are 14.5 in. up to 16 in.deep and Hutch style towers are up to 20 in. deep. the corner unit and Tower to C) Attach the wall. Choose whether you want the long hang or the double hang for the middle section. Measure the length that the rods will need to be.
4 Walk-in Closet with Corners Installation A) If you have corner units in your design, begin by assembling and placing the corner units. B) Next, assemble and place the closet towers into position. C) Install closet rods and top shelves. (Top shelves may need to be cut to size.) D) Assemble and install any doors and drawers into the tower units. E) The center towers should be placed no farther than 48 in. away from the next unit or wall. The closet rods and top shelves will only span up to 48 in.
5 Walk-In Closets without Corner Units installation and place tower units in position first. Remembering to span 48 in. or less A) Assemble between units and side walls. install closet rods and top shelves between the units and side walls using the B) Next guidelines in the instruction manuals. (Top shelves may need to be cut to size.) C) Assemble and install any doors and drawers into the tower units. © ClosetMaid Corporation 2014 | Ocala, FL 34471 | 1-800-874-0008 | www.closetmaid.com | www.