Specifications

CX335: Installation and Operation Manual Page 13
and set the ratio to its lowest setting of 1.2:1 although we do not recommend using the peak
limiter without the support of the compressor section.
8 Technical Specifications
INPUT IMPEDANCE
10kΩ
MAXIMUM INPUT LEVEL
+26dBu
OUTPUT IMPEDANCE
80 Ω
MAXIMUM OUTPUT LEVEL
+26dBu
MINIMUM OUTPUT LOAD
600Ω
FREQUENCY RESPONSE
20Hz to 20kHz ±0.5dB
CROSSTALK
<-70dB 10kHz
(All measurements referenced to 0dBu operating level)
NOISE AT UNITY GAIN
22Hz - 22KHz
-90dB
CCIR ARM
-90dB
IEC A
-92dB
DISTORTION (THD and NOISE)
100Hz 1KHz 10KHz
Unity Gain, 0dBu
<0.03% <0.02% <0.03%
+10dBu input 10db Gain Red
<0.1% <0.1% <0.1%
9 General Specifications
POWER REQUIREMENTS
110-120 Volt or 220-240 Volt at 40-60Hz, 15 Watts
FUSE RATING
100mA for 220-240 Volts, 200mA for 120 Volts
FUSE TYPE
20mm x 5mm, Class 3 type 'T' (time delay), 250 Volts working
CASE SIZE
482mm (w) x 44mm (h) x 155mm (d)
WEIGHT
3.4 kg’s (including packaging)
This product conforms to the following European EMC Standards:
BS EN 55103-1:1997
BS EN 55103-2:1997
This product has been tested for use in commercial and light industrial environments. If the equipment
is used in controlled EMC environments, the urban outdoors, heavy industrial environments or close to
railways, transmitters, overhead power lines etc. the performance of the unit may be degraded.
The product conforms to the following European electrical safety standard.
BS EN 60065:1998
Safety Considerations and Information
The unit must be earthed. Ensure that the mains power supply provides an effective earth
connection using a three-wire termination.
When the mains switch is in the off ‘O’ position the live and neutral conductors of the mains
transformer are disconnected.
CAUTION – Installation
Do not expose the unit to water or moisture
Do not expose the unit to naked flames.
Do not block or restrict any air vent
Do not operate the unit in ambient temperatures above 35
o
C
15-07-02 V3