Instructions / Assembly

WARNING

• Inspect inflatable and blower prior to use for damage. Do not use if any damage is present.

• Do not use in rain, strong wind, or extreme weather conditions.

• Always secure with ground stakes.

• Keep inflatable away from fire and heat sources.

• Do not use sharp objects in play area.

• In case of blower malfunction, tighten blower vent and evacuate play area immediately.

• Keep children away from blower. Do not insert body parts, foreign objects or clothing into blower.

• Do not exceed weight or user capacity.

• Do not allow children to play while unattended.

SETUP

1. Unroll product evenly across smooth, flat, debris-free surface. Connect blower(s) to inlet(s) and tie tightly to secure. Tie

second inlet/vent closed if applicable to your bounce house. The second vent aids in quicker deflation and should be

tied closed while in use. If applicable, anchor the blower to the ground using stakes.

2. Plug blower into 120V GFCI grounded power outlet. Use of an extension cord is not recommended. However, if needed

use the shortest length possible.

3. Turn on the blower. If using multiple blowers, turn on one at a time in 20 second intervals. Check that the air intake

port is tied closed around the blower and the second vent (if applicable) is tied closed tightly. Resolve any twists or

kinks in the air tube from blower to inflatable.

4. Secure the inflatable by staking the unit on all four corners. Drive stakes into the ground at a 45-degree angle away

from the bounce house.

TAKE DOWN

1. Confirm that bystanders have left the bounce house and surrounding areas.

2. Check for any loose objects before commencing the deflating process.

3. Turn off blower, disconnect from bounce house and unplug from outlet.

4. Open both air vent tubes and allow bouncer to deflate completely.

5. If inflatable has become wet, make sure to dry completely before folding and storing in a cool, dry area.

MAINTENANCE & REPAIRS

Special care should be taken to keep products clean, dry, and to protect seams and surface. Regularly inspect these areas for

any necessary repair. Minor damage can be repaired using the included kit.

To Repair: deflate the product thoroughly, and ensure surface is clean and dry. Cut circular patch to sizes suitable for area of

repair. Apply glue on both the repair patch and damaged surface. Allow glue to air-dry for 30 seconds before adhering the patch

to the play surface. Place a weight over the patched area. Allow to dry at least 4 hours before use.

For larger tears or a more secure repair, use light-to-medium braided fishing line to sew the hole and cover with marine grade

vinyl repair tape.

PAGE 1
WARNING • • • • • • • • • Inspect inflatable and blower prior to use for damage. Do not use if any damage is present. Do not use in rain, strong wind, or extreme weather conditions. Always secure with ground stakes. Keep inflatable away from fire and heat sources. Do not use sharp objects in play area. In case of blower malfunction, tighten blower vent and evacuate play area immediately. Keep children away from blower. Do not insert body parts, foreign objects or clothing into blower.
PAGE 2
Blower Operation For models that include a blower please refer to these instructions for important safety and operation information. WARNING • • • • • • • • Blower component is not a toy. Please keep away from children. Use only with grounded GFCI power outlet. Do not use in or near water, rain, or inclement weather. Never plug or unplug with wet hands or while standing in water. Remove small objects from the area that may be propelled or sucked into the blower before and during use.