Cloudleaf Gateway 1.5 2C4I6 Model: GW-1.
Table of Contents INTRODUCTION ..................................................................................................................................... 3 FEATURES ............................................................................................................................................. 3 PORTS & LEDS ...................................................................................................................................... 4 INSTALLATION ............................
Introduction The Cloudleaf GW-1.5 Gateways are the access point for all Cloudleaf Bluetooth based sensors tags, to communicate with the Cloudleaf cloud. The Gateway co-locates with existing indoor wireless networks via Cellular, WiFi, or Ethernet, ensuring quick & easy deployment. This also allows existing wireless network security to be leveraged, extending end-to-end security with SSL/TLS tunneling from the access point to the Cloudleaf’s Cloud. Features The GW-1.
Ports & LEDs The Gateway has the following ports & LEDs exposed: ● Power Status LED indicator ● Status1 LED indicator ● Status 2 LED indicator ● Status 3 LED indicator ● Status 4 LED indicator ● Status 5 LED indicator ● Ethernet (Power over Ethernet [POE] capable) ● SIM Slot ● Micro USB 2.0 ● 5v DC ● Reset pin hole ● Cellular antennas Ports and LEDs are same for both the models. Cloudleaf, Inc.
Installation Installing a Gateway is easy and quick, and it can usually be completed within 30 minutes. This section provides the “best practice” guidelines to get the Gateway up and running. If you have any questions or require advanced setup, please contact Cloudleaf technical support at support@Cloudleaf.io. Power A Gateway needs to be powered by external source of power. There are few ways of powering Gateway. 1. A 5V DC port requiring wall powered 5V 2A source.
Mounting Best Practices The Cloudleaf Gateway should be installed with the following guidelines: ● Each Gateway is designed to cover up to 70,000 square feet of indoor area. For best coverage and Bluetooth Low-Energy signal strength, space Gateways 200 to 250 ft. from one another. ● Install the Gateways at about 10 ft. above the ground to ensure good reception ● Avoid immediate metal structures next to the Gateway (e.g. metal beam on the ceiling), which can attenuate signal strength.
FCC Statement Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
IC Statement This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada.
RECYCLING This product bears the selective sorting symbol for Waste electrical and electronic equipment (WEEE). This means that this product must be handled pursuant to European directive 2012/19/EU in order to be recycled or dismantled to minimize its impact on the environment. User has the choice to give his product to a competent recycling organization or to the retailer when he buys a new electrical or electronic equipment.
