Owner`s manual

Club Piscine Super Fitness - Above Ground Swimming Pool - Owner’s Manual (03/2012) 14
7) CARTRIDGE FILTER
We recommend that the cartridge in cartridge filters be cleaned by hosing it down when the pressure
reads 10 pounds more than when the cartridge is clean. If it is very dirty or covered in algae, let it soak in a
solution specifically made for this for 12 to 24 hours. Rinse the cartridge and let it dry before putting it back
into the filter.
Cartridge lifespans vary with each model and depend on use and maintenance. They must be replaced
when they no longer clean the water or have lost their shape.
A three-way valve is usually installed between the pump and the filter. Turn the handle so it is pointing at
the filter when you want to drain water from your pool or when you are washing it and the water is very dirty
Note : Backwashing is not possible with a cartridge filter.
8) PUMP
The pump is the heart of the filtration system. Emptying the strainer basket is the main element of pump upkeep :
POOL WITH A BOTTOM DRAIN :
• Turn the pump off and position the three-way valve at number 2.
• Move the filter valve handle to “CLOSED” or “TEST.”
• Remove the pump lid. You may see a bit of water run out.
• Empty the dirt from the basket and rinse the basket with a garden hose.
• Put the basket back into the pump and make sure the gasket is in place before replacing the lid.
• Return the three-way valve and filter handle to their normal settings.
• Turn the pump back on.
POOL WITHOUT A BOTTOM DRAIN :
• Turn off the pump.
• Put a cloth (or plug) in the skimmer hole.
• Remove the pump lid. You may see a little water run out.
• Empty the dirt from the basket and rinse the basket with a garden hose.
• Put the basket back into the pump and make sure the gasket is in place before replacing the lid.
• Return the filter handle to its normal setting.
• You may have to add water to the strainer to replace what drained out.
• Turn the pump back on.
Note : Never use an extension cord to connect your pool pump. Instead, install a GFCI-protected
breaker near the pool. A certified electrician will be able to help you.
Note : While you are working on the pump or motor, use the time they are open to lubricate or, if needed,
replace seals, O-rings, etc. Never use Vaseline. Always select a silicon-based lubricant.