Service manual

Setup
2-21
TCP/IP SETUP Key
To enter a TCP/IP address:
1. Touch TCP/IP SETUP to display the Keyboard menu.
2. Type in the TCP/IP address.
3. Touch ENTER to initiate error checking and verify that the address is in the proper
xxx.xx.xxx.xx format (for example, 164.90.254.xx, where xx is monitor node ID).
4. When you have entered the name correctly, touch ENTER to store the name in memory.
5. Reset the monitor to have the network recognize the new TCP/IP address.
Entering an invalid IP address (for example, 89.0.3.22x) sounds an error tone and displays the
following message:
IP address 89.0.3.22x is out of range or invalid.
BED NAME Key
Touch BED NAME to display the Keyboard menu. Use the keys on the Keyboard menu to enter the
bed name assigned to the monitor. This bed name is also the monitor’s node name on the network
and is limited to five characters.
The message, Restart monitor after change in bed name: xxxxx, is displayed when
you touch BED NAME. The xxxxx is the node name currently recognized by the network. The name
you enter can contain from one to five alphanumeric characters but must be unique to the network.
Reset the monitor after you enter the bed name to allow the network to recognize the new name.
NODE DIRECTORY Key
The NODE DIRECTORY key enables you to view which nodes are active on the network. Touching
this key displays a set of node keys identifying the bed name (top) and the subnet where it belongs
(bottom):
!
• The TCP/IP settings are not currently used.
(The above names are provided only as examples.)
BED01
WARD1
BED01
WARD1
BED04
WARD1
BED05
WARD1
BED03
WARD1
BED02
WARD1
CEN01
ICU
Nodes active on the network