Instructions

270220 18
SAFE GT G1 G2 GL
Typische Anwendungsbeispiele / Typical Application Examples
Beispiel 1 / Example 1:
Not-Halt 2-kanalig mit manuellem Start (mit Überwachung der Starttaste) und Rückführungskontakten ex-
terner Schütze (Überwachung der externen Schütze via zwangsgeführte Öffner)
Emergency Stop dual channel with manual start (with monitoring of the start button) and feedback of ex-
ternal contactors (controlling of external contactors via forcibly guided NCs)
S11
24VDC
S12 S35
A1
A2S36
SAFE G
S21 S22
Start
K1ext
K2ext
O1
O2
O3
O4
K1ext
K2ext
M
Das Beispiel zeigt eine zweikanalige Not-Halt-
Anwendung mit automatischem Start. In dieser Applika-
tion wird die Starttaste überwacht.
Eine Querschlussüberwachung zwischen den beiden
Kanälen wird durchgeführt.
Die OSSDs (O1, O2, O3, O4) werden aktiviert mit dem
Öffnen des Starttasters.
Die externen Schütze werden überwacht. Ein Ver-
schweißen eines Schließers wird nicht direkt erkannt,
es ist aber sichergestellt, dass die OSSDs nicht durch-
geschaltet werden (und somit das fehlerfreie Relais
nicht schaltet).
Sofern eine Überwachung der externen Schütze nicht
erforderlich ist, können die Öffner einfach durch eine
Brücke ersetzt werden.
Bitte vergleichen Sie auch "Leistungsausgänge
OSSDs".
Erreichbare Kennwerte: Kat4, SIL3, PLe
Die Ermittlung der Kennwerte für die Gesamtapplikation
liegt in der Verantwortung des Anwenders.
This example shows a dual channel emergency stop
application. In this application the start button is moni-
tored.
The channels are controlled against cross circuit.
The OSSDs (O1, O2, O3, O4) are activated if the start
button is released.
The external contactors are monitored. A welding of a
NO cannot been recognized, but for sure the OSSDs
will not switch through (and for this the faultless contac-
tor will not become activated).
In the case that no controlling of the external contactors
is needed, the NCs can be easily exchanged with a
bridge.
Please compare with "Power Outputs OSSDs"
Reachable parameters: Cat4, SIL3, PLe
The user is responsible for the calculation of the final
parameters.