Installation Manual

Connect hard wire power supply from

dishmachine to power box.

MODEL AH REAR VIEW

11-2005

DRAIN HOSE

HARD WIRE

FOUR WIRE

POWER SUPPLY

Connect the drain pipe from scrap

accumulator to floor or wall drain.

Connect dishmachine to hot water source

recommended 140

temperature. (120

minimum temperature required).

STEP

WALL

DRAIN

FLOOR DRAIN

STEP

Insert tube stiffener with chemical tubing into

corresponding chemical dispensers.

BLUE

RED

WHITE

STEP

TUBE

STIFFENER

AUTO START

SWITCH

POWER SWITCH

2" DRAIN

OUTLET

CHEMICAL

TUBING

3/4" WATER

INLET

HARD WIRE

POWER SUPPLY

Models AH, C, B, CB

Quick Setup

Instructions

60"

11"

PAGE 1
Models AH, C, B, CB Quick Setup Instructions MODEL AH REAR VIEW POWER SWITCH 7" HARD WIRE POWER SUPPLY 2 3/4" WATER INLET 3 STEP 1 AUTO START SWITCH TUBE STIFFENER WALL DRAIN FLOOR DRAIN Connect the drain pipe from scrap accumulator to floor or wall drain. CHEMICAL TUBING 4 4 60" STEP 2 11" Connect hard wire power supply from dishmachine to power box. STEP 3 Connect dishmachine to hot water source recommended 1400 temperature. (1200 minimum temperature required).
PAGE 2
Models AH, C, B, CB Quick Setup 6 Instructions MODEL AH FRONT VIEW PRIMER SWITCHES PERISTALTIC PUMP FILL/START SWITCH 7 DOOR HANDLE 8 STEP 5 Level dishmachine by adjusting leveling legs. Dishmachine must be level front and back. STEP 6 LLIF Press and hold down the three Primer Toggle Switches for the chemical pumps until product is discharging into the machine.