Installation Sheet

ManualsBrandsCMA Dishmachines ManualsDishwasherL-1X16

Insert tube stiffener with chemical tubing into

corresponding chemical dispensers.

STEP

BLUE RED

WHITE

STEP

Connect 110/120V, 60HZ hard wired power

supply to power box. DO NOT USE POWER

CORD OR GFI OUTLET.

L -1X16 / L -1X

Quick Setup

Instructions

ELECTRICAL

CONNECTION

TUBE

STIFFENER

CHEMICAL

TUBING

DRAIN HOSE

CONNECTION

1/2" WATER INLET

LEVELING LEGS

Connect the drain hose to wall or floor drain.

The floor drain must have a 1 inch air gap

between drain hose and floor drain.

WALL DRAIN

FLOOR DRAIN

1"AIR GAP

STEP

WARNING: Electrical and plumbing

connections need to be made by a

licensed service person and comply

with all Federal, State and Local

Health, Electrical, Plumbing and

Safety codes.

11-2016

REAR VIEW

HOT

NEUTRAL

GROUND

Connect dishmachine to hot water source

recommended 140

temperature (120

minimum temperature required).

STEP

Level dishmachine by adjusting leveling legs.

Dishmachine must be level front and back to

ensure proper performance.

STEP

L-1X16 LEG

ADJUSTER

L-1X LEG

ADJUSTER

PN: 10130.11

Summary of content (2 pages)

PAGE 1
L -1X16 / L -1X Quick Setup Instructions REAR VIEW ELECTRICAL CONNECTION WARNING: Electrical and plumbing connections need to be made by a licensed service person and comply with all Federal, State and Local Health, Electrical, Plumbing and Safety codes.
PAGE 2
L -1X16 / L -1X Quick Setup Instructions FRONT VIEW DELIMER TO OPERATE MACHINE SET SWITCH TO NORMAL WARNING: Electrical and plumbing connections need to be made by a licensed service person and comply with all Federal, State and Local Health, Electrical, Plumbing and Safety codes. FILL / START 8 DRAIN POWER 6 DETERGENT PRIME SWITCH 7 SANI PRIME SWITCH 7 RINSE PRIME SWITCH 7 STEP 6 ON OFF POWER DRAIN CHEMICAL PUMPS FILL/START Turn power switch to "ON" position.