User's Manual

Integration instructions for host product manufacturers according to UHF Module user manual
2.2 List of applicable FCC rules
Part 15.247
2.3 Specific operational use conditions
The module is limited to installation in mobile or fixed application.
A separate approval is required for all other operating configurations, including portable configurations
with respect to Part 2.1093 and difference antenna configurations.
2.4 Limited module procedures
Not applicable as this is not a limited modular.
2.5 Trace antenna designs
Not applicable as there is no trace antenna design in this modular.
2.6 RF exposure considerations
For the end host, the antennas used for this transmitter must be installed to provide a separation
distance of at least 20cm from all persons and must not be collocated or operating in conjunction with
any other antenna or transmitter.
2.7 Antennas
For 902MHz-928MHz
2.8 Label and compliance information
Host product manufacturers are required to provide a physical or e-label stating “Contains FCC ID:
2AC9W-CMC303” with their finished product.
2.9 Information on test modes and additional testing requirements
Test modes should take into consideration different operational conditions for a stand-alone modular
transmitter in a host, as well as for multiple simultaneously transmitting modules or other transmitters
in a host product.
2.10 Additional testing, Part 15 Subpart B disclaimer
This modular transmitter is only FCC authorized for FCC Part 15.247 as listed on the grant, and the
host product manufacturer is responsible for compliance to any other FCC rules that apply to the host
not covered by the modular transmitter grant of certification. The final host product still requires Part
15 Subpart B compliance testing with the modular transmitter installed.