User`s manual

2 Installation Guide

2.1 Power Supply

1. Make sure the power switch is set to OFF.

2. Connect the AC adaptor to the POWER IN port in the rear panel.

3. Make sure the AC requirement of the AC adaptor is compliant with the local AC

supply, then connect the AC adaptor to the power supply outlet.

Make sure the AC requirement of the AC adaptor is compliant with the local

AC supply, otherwise it will cause severe damage to the AC adaptor or the

instrument, and it may cause electrical shock!

Only the AC adaptor designed for this product should be used. If you cannot

find the right adaptor or the adaptor does not work, please contact local CME

dealers. The usage of an improper adaptor may cause fire or electrical shock!

The AC adaptor varies from country to country. If you take the product from

one country to another, please make sure your AC adaptor compliant with the

local power supply. If you are not sure about the technical information for the

power supply or the adaptor, you can consult a qualified local electrical

engineer.

2.2 Power On Order

When you have this product connected to a system, please set all the volumes to

minimum then follow the proper order to turn all the devices on: master MIDI device

(which sends out MIDI data), slave MIDI device (which receives MIDI data), audio

devices (mixer, amplifier, speakers). When you follow this order, all the signals (MIDI and

audio) will go properly from the beginning to the end. If you will turn off the system,

please follow the reverse order (turn off the audio devices first, then the MIDI deivces).